Microcement Walls – Microfinishing

Traditionally, Fine and Smooth Microcement

This Microcement, Traditionally, was made to be used in walls, ceiling, countertops, sinks, shower trays and surfaces low traffic. With a silky finish this coating is very pleasant to the touch. The Microfinishing when used for coating walls, it may sometimes be confused with stucco, but the finishing of this kind of Microcement is more natural because the design is not repeatable and doesn’t follow a visible structure.

The Microtraffic may also be used to coat walls without compromising the reliability of the material.

Microfinishing – Correct Application

A good application of Microcement should not let never guess where staff began applying the coating or where it ended. Should generally avoid the straight lines and replce by curved planes, not more than 2 times in the same direction.

Isn’t possible exclude or hide the Microfinishing walls caracteristics because that is a desired effect in this kind of Microcement. If you want a more homogenous look can choose the Microtraffic, although we recommend it to floor coating. The Microtraffic, when applied in wall requires a specialized finish to look like Microfinishing.

See some Microfinishing applications.

Highly Resistant Coating

The resistance of Microcement is much higher than any lime plaster because, as the name suggests, consists mainly of cement, as well as acrylic resins of high quality.

For the flooring we have other types of high strength Microcement as Microtraffic, Micronoslip or Poolciment. Traditional Microcement

For the flooring we have other types of higly strenght Microcement such as Microtraffic or Micronoslip. Microcement Traditional – Microfinishing – is the most delicate material of the whole family.

Microfinishing Application

Mix and Income

• 10 Kg – 4,5 L Royal Resin
• 2 Coats – 0,5 Kg/m²

Application Process 

– The Microfinishing is applied over Microbase in two coats with a rubber or metal trowel,

– We must always respect the mixing proportions recommended,

– Allow to dry 3 hours between each coat,

– Manually sand each coat,

– For microfinishing layer should not exceed a thickness of 0.3 millimeters,

– After leaving the surface dry, between 24h and 48h, apply Sealer.